Radius network mac address how to#

In order to add a new access point to the system, please see How to add an access point.īelow you can find the updated parameters to enter when configuring your device. The MAC address is the value marked in red.Įntering the device details into the Cloud4Wi Dashboardįor Cambium Networks devices, the Cloud4Wi Dashboard requires only the MAC address. The result should be similar to the one below:Į400-F83362(config)# show interface brief You can find your MAC address in the rear of the device (please check the value called ESN).Īlternatively, you can find it this value entering the CLI (username: admin) after typing the command show interface brief. it is necessary to set the MAC address of your device also in the Cloud4Wi Dashboard.the value of the NAS identifier input at Configure > WLAN, in the Radius server tab, depends on the MAC address of your device.It is necessary that you know the MAC address of the device. Accounting server 2 (Host, Port, Secret)įor the NAS Identifier value, you have to enter the MAC address of the device without any separator (e.g.Accounting server 1 ( Host, Port, Secret).Authentication server 2 (Host, Port, Secret).

Authentication server 1 ( Host, Port, Secret).

Please go to the Radius server tab, in the same page where you configured the previous steps ( Configure → WLAN), and enter the following data:

Walled garden for PayPal feature (websites/domains to open).

Walled garden for the Social Login (websites/domains to open).

You can learn more about that by reading the following articles: Otherwise, the redirection to the Splash Page will not correctly work. Please note that it is mandatory to set the following entry: *. In the same page (under Guest Access) it is possible to configure the walled garden by inserting wildcards. Please set these fields with the updated parameters that you can find in the paragraph below called 'Parameters for the Solution'. Please go to the Guest Access tab, on the same page where you configured the previous steps ( Configure → WLAN) and enter the following data: The first step is to create a WLAN ( Configure → WLAN) and set up the open SSID you wish to use for the guest-access. In order to configure your device with Cloud4Wi, please open a web browser and put the following link: and log in as 'admin' user.

have an IP address assigned to the a through DHCP or static.

The following access point models are supported:īefore integrating the controller with Cloud4Wi, it is necessary that the controller and access point: The configuration procedure has been performed and tested on a cnPilot E400 running the firmware version 2.5.1-b2. Therefore, please check the data contained in the article 'Parameters for the Solution' at the bottom of the page, as they are certainly up to date.

Please note that the images contained in this article may contain outdated configuration data. This guide shows how to configure a Cambium Networks access point for Cloud4Wi.